GSM/GPRS Communicator. The BGSM-G gives total confidence in all security and surveillance applications and is the ideal way of completing whatever system . (see instructions), and then close the B-GSM. + Screw the 3[G]. In the event of GSM network signal fail- ure a signal as per figure 3b will be present on terminal . The BGSM-G-EU is Bentel’s all new universal global system mobile (GSM) alarm communicator is a versatile device that accommodates end-users that are not.

Author: Shakazilkree Tojaramar
Country: Uganda
Language: English (Spanish)
Genre: Life
Published (Last): 11 September 2015
Pages: 46
PDF File Size: 13.19 Mb
ePub File Size: 16.38 Mb
ISBN: 504-4-54927-319-8
Downloads: 71669
Price: Free* [*Free Regsitration Required]
Uploader: Kasar

Remove the screw and the front cover [1].

Route wires as indicated in Figure 1. It has home remote automation capabilities and a full event report program. Fit the antenna [2] ensure manuql the bolt [3] is fastened tightly.

The performance of this Device depends greatly on GSM Network coverage, therefore, it should not be mounted without first performing placement tests to determine the best location for reception minimun one green LED is ON. Description This Device manages SMS and Central Station transmissions and can simulate the land line in the event of trouble land line down or even substitute the land line completely in areas where the GSM service is bbgsm-g and where the land line is not available.


BGSM-G Universal Alarm

Before inserting or removing the SIM card, please ensure the unit is powered down. This Device has 4 Outputs which can be set up from remote locations or used for status signalling.

More information about Elvey Security Technologies. Reattach the front cover [1] securely to the bsm-g. The communicator connects the alarm control panel to the GSM network to report alarm signals directly to the monitoring station receiver, and is compatible with any control panel that communicates using the Contact ID format.


Using anchor screws not includedmount the cabinet to the wall. This Device must be installed indoors in a non-hazardous location. Enhancing home automation with IoT OctoberKanual Security TechnologiesMajual, Integrated Solutions By automating elements which are electronically driven, homeowners are given the power to improve their quality of life by implementing these enabling technologies and controlling them via a smart device. Complete the connections on the terminal board [12].

Your name Your email address Their name Their email address Your message The details submitted in this form will not be shared with any third parties.

Bentel Interfaccia-combinatore GSM: BGSM-G-EU

There is also an account supervision feature that sends out information via IP in the event of a communication failure. The details submitted in this form will not be shared with any third parties.

  DODI 8500.2 PDF

This Bvsm-g should be located in a safe dry place away from radio transmitters and similar devices. Using the connector [5], connect the GSM Module [17].

Using the cabinet, mark the 4 screw locations then drill the anchor screw holes. It can effectively monitor optical lengths of up to km per controller for buried, and 80 km for fence installations.

Check for cable conduits and water pipes before drilling. Lay the cables, then pull them through the cable entry [14].

The communicator is protected against tampering and provides tamper signals on two terminals, while the device can also be programmed and controlled via a PC software application which is available as an accessory. The SMS dialler function manages telephone numbers and sends trouble alert, periodic transmissions and pay-as-you-go balance messages. This Week’s Editor’s Pick. If both are ON, it indicates perfect coverage. The content of this article