Le rogamos que copie e imprima aquí el manual operativo correspondiente en su idioma. Francais Copiez et imprimez ici la notice d’utilisation dans la langue. SERVICE MANUALScrew Compressor Model: SX 6 classic No.: 9__00USE Contents. KAESER SX6 COMPRESSOR MANUAL SMVLPIMPCZ | PDF | | 24 Aug, TABLE OF KAESER SX6 COMPRESSOR MANUAL.

Author: Mazugami Kajikree
Country: Germany
Language: English (Spanish)
Genre: Medical
Published (Last): 10 November 2005
Pages: 381
PDF File Size: 2.53 Mb
ePub File Size: 19.61 Mb
ISBN: 298-9-19121-366-5
Downloads: 81449
Price: Free* [*Free Regsitration Required]
Uploader: Samuzil

Setting the pressure switch. Place desiccant inside the machine cabinet.

Start the machine and allow to run for ten minutes then switch off, check the oil level and kaewer up if necessary. After a few minutes of operation, stop the machine and check for leaks.

Manuals – Manuales – Notices d’utilisation – Bedienungsanleitungen

Hazards from compressed air. Turn the kaesed screw 2 anticlockwise with a screwdriver. Cooling air supply is inadequate. The compresor motor is stopped. Change the oil filter.

Clean the cooler with a jet of water or steam. Machine is cooled down. Manually venting the compressed air cooler Remove the screw 1 and carefully release pressure. Closing the air filter housing Clean all parts and sealing surfaces.


Switch machine off and check for leaks. Slowly open the shut off valve 11 to allow oil to drain out and close immediately when air begins to escape.

KAESER SX6 Service Manual

Make sure you give the data from the nameplate. Alternatively, an external source of compressed air can be used. Proper use also includes compliance with the instructions in this manual.

Do not touch surface danger of burning. kaeswr

The user must provide the machine with a lockable supply disconnecting device. Maximum working pressure [psig] Tab.


Run the machine once a week under load for at least 30 minutes to ensure corrosion protection. Close and lock the maintenance canopy. Heat the compressor kzeser or install an axuliary heater in the compressor.

Dispose of the old oil in accordance with local environment protection regulations. The nameplate is found inside the machine. Observe approved safety regulations and national legislation applicable to all work carried out on the machine. Top up as soon as the oil level reaches the minimum 5b. Air leak in unit. Check for open valves, loose connections, defective tools, etc.


The pressure system is vented.

Hand the machine over to an authorized disposal expert. Mains power switch off and locked out.

Before the machine is switched on for the first time the user must provide and check measures to guard against electric shock by direct or indirect contact.

Socket is still in the hose coupling at the oil separator tank or aftercooler.